Hi Marctje,

If I understand you correctly, you want to create an L-formed table.

The best approach is to draw a surface with the measurements you've given as follows:

- Right-click on the work area, and select 'Add line/surface'.
A line with two endpoints appears.
- Right click on an endpoint, and select 'Add point'.
A third point appears
- Repeat this another three times, as you need six points in total.
- Right click on a point, and select 'Close line'
Your line becomes a surface.
- Now, drag the points into place to form the L-formed table. While you drag a point, you can see its coordinates in the status bar below.
- If you wish to position the points precisely, double click them and set the x and y coordinates.

I hope this helps!

BTW: What do you want with the poll?
<edit: the poll has been removed>

David.