AnyRail Model Railroad Forum » General Category » Tips and tricks » Fleischmann Profi - Curved Turnouts
Pages: [1]
« previous next »
Print
Author Topic: Fleischmann Profi - Curved Turnouts  (Read 932 times)
Thrush
Newbie
*
Posts: 26


Kazincbarcika, Hungary, Europe


Email
« on: January 13, 2008, 12:04:37 PM »
Hello!

I maked some curved turnouts. I hope someone can use these plans.

Best regards,

Thrush
* Thrush-FleischmannProfi-CurvedTurnouts.drl (100.31 KB - downloaded 58 times.)
« Last Edit: January 28, 2008, 08:37:55 PM by Thrush » Logged
kimbo
Jr. Member
**
Posts: 97

frenchykimbo@hotmail.com
WWW Email
« Reply #1 on: January 13, 2008, 12:24:03 PM »
 Cool Beautiful curved turnouts!!! Nicely done!
Logged
Kim
Living in: Brussels, Belgium
DRail user since: 26/12/2007
Dream layout: An HO-Scale freelance layout set in an imaginary European country located close to Belgium, Germany, and Netherlands
David
Administrator
Sr. Member
*****
Posts: 276


Email
« Reply #2 on: January 13, 2008, 01:15:20 PM »
It is a public secret that the Fleischmann Profi curved turnouts do not fit perfectly. A little bit of wiggling or cheating is required to make a nice fit. When laying the rail track, you will hardly notice that you are doing this.

Of course, problems like this with the geometry become immediately apparent in a CAD tool or rail planning tool such as DRail.
We've had many questions about this.

What we did is that we measured the original turnouts and represented them in DRail exactly as they are. Apart from that, DRail gives you the option to 'cheat' by turning off the 'snap' option, and increasing the tolerances (please see the manual if you want to know how to do this).

I attached two examples where you can see the result. If you zoom in you can see where I 'cheated'.

Of course, you can copy and paste the examples into your own track plan.

David.
* Fleischmann_Profi_curved_turnouts.drl (24.29 KB - downloaded 45 times.)
Logged
Pages: [1]
Print
« previous next »
Jump to: