Version 3.15.0

[David]

On today's new release the following features have been added:

- Show percentage of slopes. This helps a lot when working with heights
- Better indication of points where height is locked. Again to make working with heights a bit easier
- Change height for this point only: Change the height of a point without influencing the rest of the track

- A new function for flex track: When pressing SHIFT while moving the controls points, the control points will move on a straight line. This because of the following message we received:

"I often find myself adjusting the length of a straight piece of flexible track to fit into a given space.  This involves moving the slider(s) in a straight line.  I must admit I find this difficult and end up with the piece of track being not quite straight.
I realize you can change the length of the track but I find I do not know the length I require.
My solution would be to have the facility whereby if you press the shift key while moving the slider the slider will move in a straight line."

David.