Another section question

[nickj]

Further to my previous post, Anyrail creates a section based on the position on the isolators.  But I will need to control a section containing a number of turnouts and each will need to be isolated to be able to use currect detection to monitor turnout position.  Is there a way to combine a number of sections into one ?

Quite possibly I am asking to much of Anyrail in wanting to move from pure layout into layout control design.

regards
Nick

[David]

You can isolate each individual turnout and give it a section name.
It's not yet possible to combine sections into 'blocks'.
Perhaps, using a naming scheme, you can work around this?

[Vectorer]

It's been 9 years, is this possible yet?
I'd like to make a Kato Double Crossover one section and not 4.
Thanks.

[David]

Please make sure to power the Kato double crossover on all four ends, as the middle tracks are insulated.

There's no way to make one section of it, only if you go all the way around and have a loop that eventually connects all ends.

Of course you can create four sections and wire them from one source.