Ruler Problem

[RCMan]

I undated to the latest version and setup the the rulers for Left and Top. When displayed on the screen the fonts size was way to small and went back to make it bigger however, it was difficult to change the font size and it would not let me put my own size.

Also the ruler numbers stopped at 96, I guess this is inches.  My layout is over 500 x 500 inches and only get the ruler marks after 96.

[Mike from CT]

I undated to the latest version and setup the the rulers for Left and Top. When displayed on the screen the fonts size was way to small and went back to make it bigger however, it was difficult to change the font size and it would not let me put my own size.

Also the ruler numbers stopped at 96, I guess this is inches.  My layout is over 500 x 500 inches and only get the ruler marks after 96.

You can adjust ruler font size by adjusting the margin size. (Help - Options - and enter "Width size") 0.2 works for me.

As for ending at 96.... are you zoomed out to see the whole layout or just a portion? Try scrolling to see rest.

[David]

The numbers are only displayed if they fit, to avoid values displayed on top of each other.

It might be that '96', having two digits, still fits, but '100', with two digits, does not. If you zoom out, they should appear.

[RCMan]

The numbers are only displayed if they fit, to avoid values displayed on top of each other.

It might be that '96', having two digits, still fits, but '100', with two digits, does not. If you zoom out, they should appear.

I will look at this later.

Thanks
Dennis