Bug in Minitrix 14947 & 14948 (curved turnout 30°/R3/R4)

[Bastelmaxx]

Hello,

the planning with these Minitrix curved tournouts are not correct/not possible. When you complement the turnout with the right curved tracks (14927) you get not the right angle (60°).

Could you fixed this bug, please?

Thank you very much.

Best regards,
Marc

[VictorPM]

Hi Marc,

It's not a bug, it's a feature 
Or: don't blame the messenger 
Digital programs like Anyrail only show the items as they are.
It's the geometry by Minitrix that is imperfect.
The inner and outer curve of the turnout are "spread" under an angle. Otherwise it would not be possible to even reach the parallel track within 60°.
So, you will never get both curves under the same parallel angle. You will have to disconnect and fiddle around with it a little. Only digitally it's a problem, not in practice when laying out the real tracks 
Never blame Anyrail   

Greetings, Victor

[Bastelmaxx]

Hello Victor,

thanks for your information. This is really strange....but i believe you 

Minitrix tracks are very expensive. I don't understand this company....


Best regards,
Marc