Version 7.2

[David]

In this update, the major change is how 'flip' is handled.

In some cases, mirroring a part is not possible because it's not symmetrical.
Think of an uncoupler with a magnetic coil on one side.
These parts are now rotated instead of mirrored when you use the 'Flip' function.
I've attached an example.


Other small changes:
Displaying inaccurate connections with a red diamond on the connector can now be switched off on the Show tab.
An inaccurate connection is when a gap is larger than 0.5mm, or a kink of more than 0.3 degrees.

TT Tillig Modell: new EW1 turnouts added.