Changing Track & Turnouts

[Fuzzy49]

I am trying this again. I was hoping Dave [the creator of this fine program] would help me.

In the Plan I used the [500 Atlas code 83 Flex 36"] on the entire plan. I also used the Code 83 Turnouts too.

Now is there a way to change to the [168 Atlas code 100 Flex 36"], and the turnouts too?

Doing all the track at one time without doing it the hard way, piece at a time. The same with the Turnouts.

Thank you
Fuzzy49

[David]

This is not possible. In general, different track systems have a different geometry.
Also, track that's is available in Code 100 may or may not be available in Code 83.

The quickest solution might be to lock the old Code 83 plan in a layer and then trace/redraw it with the Code 100 track.

By the way, why are you changing to code 100? Personally, I think Code 83 track is much nicer.